Battery Monitor Guide

The BatteryHub which is intended for use in situations where you need reliable battery performance.

Weight: 19.5 kg

Dimensions: 33 x 42 x 18 cm

Safety Features

Our batteries use an onboard battery management system to control temperate and over-charging and performance. Only use the authorised and approved charger.

Once the battery has been installed on site, proper care and maintenance of the battery is critical. Do not fully discharge the battery as this may stop you from being able to recharge the battery.

Do not exposure the battery to direct sunlight, heat or fire. Do not open the battery as this could cause electrocution, injury or fire.

Performance

The 200 aH battery is compatible with the following monitors.

NoiseSens EM2030 Noise Monitor: Provides up to 30 days power.

DustSens DM30 & N Monitor: Provides up to 5 days power.

Turning On The Battery for Operation

To operate the battery ensure it is turn on always.

Charging the Battery

The smaller connector on the right should be used for recharging the battery. The charging time is 20 hours to full or 10 hours with a fast charger. Press the power button to turn on the battery display.

Power Supply

Use the large left connector for powering your noise monitor. 

Battery Packs

When installing your battery pack, install it off the ground so it doesn’t get stuck in a puddle of water.